CiscoCCNP：CIT2

ciscoCCNP：ciT2
 

101. Which of the following are valid case priorITIEs for a cisco TAC?
a. Priority 1 - Production network sITuation down*
b. PriorITy 2 - Production network performance seriously degraded
c. PriorITy 3 - Production performance degraded
d. PriorITy 4 - Information needed about cisco products

102. What feature must be configured on a cisco router if NetBEUI is to be moved across remote networks?
a. Static route
b. Helper addresses
c. Source-routing bridging*
d. All of the above

103. Which of the following commands will provide the administrator wITh a list of Novell servers on the network?
a. show ipx traffic
b. debug ipx ipxwan
c. show ipx route
d. show ipx servers*

104. What command displays the ring state information as well as hardware and microcode version information?
a. show interfaces tokenring
b. show controllers token*
c. show interfaces
d. show controllers serial

105. What information will be provided by the ‘debug ip packet’ command?
a. Information regarding IP packets*
b. Information regarding any packet that transITs the router
c. Information regarding IP routing events
d. Information regarding TCP sessions

106. What command lists the output of the currently running configuration and the state of the router?

107. Catalyst swITches can place two or more VLANs on a single non-trunk port. True or false?
a. True
b. False*

108. What IOS command displays the contents of the internal FLASH memory?

109. You have just finished entering a serIEs of debug commands. The performance of the router has dramatically degraded and none of the debugging commands have reached the terminal. Which of the following are most likely to have caused the problem?
a. The router has lost ITs configuration stored in NVRAM
b. The router contains a version of IOS that does not understand one of the debug commands you issued
c. The router was overlOAded causing severe performance degradation because the ‘debug all’ command was entered*
d. The ‘terminal monITor’ command was never issued*

110. What command lists the information about the configured ring speed and bridging capabilITIEs?

111. Which of the following troubleshooting steps should be documented?
a. Observing the problem*
b. Generate errors
c. Define the problem*
d. Implement the action plan*
e. Observe changes*

..............................