FRNC-5PC工艺计算软件操作指南(DOC 34页)

1......总则......3
1.1 主要应用......3
1.2 相关标准及参考书籍......3
2......软件简介......4
2.1软件使用范围......4
2.1软件计算方法......5
2.1.1固定发热量（固定燃料量）......5
2.1.2固定热负荷......5
3......输入部分......6
3.1 燃烧室输入......6
3.1.1 Characteristic......6
3.1.2 Furnace type......7
3.1.3 Furnace dimension......8
3.1.4 Flue Gas “Take-Off”......9
3.1.5 The ID’s of Coil Sections in Firebox......9
3.2 对流室输入......10
3.2.1 Characteristic......10
3.2.2 Internal Duct Dimensions......11
3.2.3 Coil Section, Q-Bank, or Air Preheater ID......11
3.3 烟囱输入......11
3.3.1 Characteristic......11
3.3.2 Geometry......12
3.4管路输入......12
3.4.1 Geometry......13
3.4. 2 Process fluid......13
3.4.3 Geometry I......14
3.4.4 Geometry II......14
3.4.5 Additional data......16
3.4.6 Additional data......17
3.5炉管数据输入......18
3.5.1 General characteristics......18
3.5.2 Fin type and diameter......19
3.5.3 Fin data......20
3.6物料数据输入......21
3.6.1 Process stream Characteristic......21
3.6.2Condition......21
3.7燃烧数据输入......22
3.7.1 Firing data......22
3.7.2 Bridge wall temperature......24
3.7.3 Fuel #1......24
3.8燃料数据输入......25
3.8.1 Identification......25
3.8.2 Composition......26
3.9热损失输入......27
3.10注入水蒸气/水数据......27
3.11Q-BANK输入......28
3.12空气数据输入......29
3.13空气预热器输入......30
3.13.1 General Characteristic......30
3.13.2 Specification......30
3.14物理数据输入......31
3.14.1 自动生成的物理性质......32
3.14.2 直接输入的物理数据......32
3.14.3 仅仅生成的物理属性数据......32
4......输出部分......32
4.1输入数据的重现......32
4.2输入数据的处理......33
4.3物理属性数据的重现......33
4.4计算过程输出......33
4.4最终结果输出......33

..............................